Vanden Plas (X308) V8-4.0L (AJ27) (2000)
2. Slacken, remove and discard 1/4 turn fastener securing each heelboard trim panel and withdraw both panels for access.
3. Slacken and remove the seat cushion securing screws.
4. Raise rear of cushion, disconnect heater element harness multiplugs (if fitted), and move cushion forward carefully feeding seat belt buckles past
cushion cut-outs.
5. Remove seat cushion from vehicle.
Installation
1. Holding outer seat belts clear, position cushion in vehicle with rear edge raised.
2. Position buckle assemblies and carefully feed them past cut-outs in cushion.