Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-740010.png)
11. CAUTION: Only remove the bolts securing the caliper anchor bracket to the vertical link. Refer to caution above for more information.
Remove caliper from vertical link.
Remove bolts.
12. Remove brake dust and clean mating surfaces. See Warning above.
Installation
1. Install caliper to vertical link.
Install and tighten bolts to 140 Nm.
2. CAUTION:
^
Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work, with clean
water.
^
Note the condition of pins and 'R' clips and replace if necessary.
Install brake pads into caliper.
Slowly retract caliper pistons.
Install pads.
Position anti-raffle spring.
Install pins.
