Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-753004.png)
1. Install brake disc to wheel studs.
Make sure hub and brake disc access holes are aligned.
2. Set the parking brake.
3. Check brake disc run-out.
4. Install caliper carrier to hub carrier.
Position carrier.
Install and tighten bolts to 60 Nm.
5. CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work,
with clean water.
Slowly retract piston into caliper housing.
