Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Installation
1. Install master cylinder to brake booster.
Install seal to master cylinder.
Install master cylinder, make sure master cylinder rod locates brake booster rod.
2. Install and tighten nuts to 21 - 29 Nm.
3. Install brake booster and master cylinder assembly.
4. Install pedal housing, brake booster and master cylinder assembly.
5. Install engine compartment rear cover.
6. Reconnect battery ground cable.
7. Bleed brake system.
8. Remove paint-work protection covers and close engine compartment.