Vanden Plas (X308) V8-4.0L (AJ27) (2000)
6. Tighten bleed nipples to:
Front caliper bleed nipple 4 - 6 Nm.
Rear caliper bleed nipple 8 - 11 Nm.
Remove bleed tubes and containers.
7. Disconnect electrical connectors from ABS/TCCM.
Pull plunger upwards.
Disconnect electrical connector.
Disconnect electrical connector
8. CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.
Position an absorbent cloth underneath the HCU to collect brake fluid spillage.
9. NOTE: To minimize brake fluid loss, release the brake tubes from the HCU in the order shown.