Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-317002.png)
6. Hold the tool against the crankshaft and lightly and evenly tighten the two nuts to the face of the tool; to secure the tool and to hold it parallel to
the face of the crankshaft.
7. Secure the oil seal to the tool using the three self-tapping screws spaced evenly around the face of the tool.
Use the punch (provided) and a hammer to pierce the seal face and provide a pilot hole for one of the self-tapping screws provided.
Install a self-tapping screw and tighten by 1-1/2 turns only.
DO NOT TIGHTEN BY MORE THAN TWO TURNS OR THE SCREW MAY BREAK.
Repeat the above steps for the other two screws.
8. Hold the two bolts stationary and loosen fully the two nuts.
