Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-318004.png)
1. Locate the new oil seal into the timing cover.
Remove the transit ring from the oil seal.
Position the seal to the timing cover.
2. Install the new oil seal to the timing cover.
3. Install oil seal replacer tool 303-542 to the oil seal.
Use the nut and bolt provided with the tool, to fully seat the seal to the timing cover.
Only tighten the nut sufficiently to locate the seal and no more or the timing cover could become distorted.
Allow the tool to stay in position against the seal (or at least five seconds.
Remove the special tool from the seal.
If the damper is not to be installed immediately, the transit ring should be installed temporarily to the seal.
4. Install a new O-ring seal to the damper.
