Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-336002.png)
7. Slacken the three screws which secure the water pump pulley.
8. Remove the drive belt from the generator and accessory drive.
Use a spanner e.g. Churchill JD-230 or Snap On XDHM 1415, on the center bolt of the belt tensioner idler pulley, to turn the adjuster assembly to
the left against spring tension.
Whilst holding the tensioner against spring tension, remove the drive belt from the generator pulley.
Release the tensioner slowly and remove the spanner.
Disconnect the belt from the other pulleys and remove it..
9. Remove the pulley from the water pump.
Remove the pulley securing screws.
Remove the pulley from the water pump.
10. Remove the belt tensioner assembly, from the Front Accessory Drive. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt
Tensioner/Service and Repair
11. Remove the idler pulley, from the Front Accessory Drive. See: Drive Belts, Mounts, Brackets and Accessories/Idler Pulley/Service and Repair
