Vanden Plas (X308) V8-4.0L (AJ27) (2000)
11. Remove ABS/TCCM from the HCU.
Place the HCU on a work bench.
Disconnect electrical connector.
Remove bolts.
Remove ABS/TCCM.
12. Clean components and mating surfaces.
Installation
1. Install the ABS/TCCM to the HCU.
Install and tighten bolts.
Connect electrical connector.
2. Install HCU.
Taking care not to distort brake tubes position HCU into bracket.
Install bolts and tighten to 8 - 10 Nm.