Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-890007.png)
warranty purposes.
27. Thoroughly clean wishbone paying particular attention to ball joint and pivot bolt locations.
Installation
1. Install ball joint in wishbone.
Position support of special tool 204-199 on press bed and place wishbone on tool.
Using ball joint plastic cover to align, position mandrel of special tool 204-199 on ball joint
Align assembly with press ram and operate press to fully seat ball joint in wishbone.
2. Remove tool mandrel 204-199 from ball joint.
3. Remove wishbone and support tool 204-199 from press.
4. Position wishbone on suspension beam, install fulcrum shaft thread rearward, install nut and tighten to 60 - 80 Nm.
