Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-893007.png)
Install special tool 204-192 on ball joint.
Tighten tool bolt to release ball joint taper pin from vertical link.
20. Remove special tool 204-192 from ball joint.
21. Remove vertical link/hub assembly.
Supporting vertical link/ hub assembly, remove lower wishbone ball joint nut.
Remove vertical link /hub assembly.
22. Remove stabilizer bar link to wishbone bracket securing nut and bolt.
23. Remove wishbone front arm to rear arm securing bolt.
