Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-898012.png)
14. Ensure that both engine hydramounts are correctly seated in crossbeam locations.
15. Install crossbeam rear mountings.
-
Align rear mounting rubber with body location.
-
Install rear mounting securing bolt and nut and tighten nut to 131-185 Nm.
-
Repeat procedure to install opposite side rear mounting bolt and nut.
16. From engine compartment, install but do not tighten crossbeam front RH bolts.
17. From engine compartment, install crossbeam front LH bolts and tighten to 22-28 Nm.
18. Install power steering fluid reservoir.
-
Position reservoir on mounting bracket.
-
Install reservoir securing nuts and bolts.
