Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-908010.png)
11. Tighten new link arm to wishbone nut and bolt to 41-54 Nm.
12. Secure new link arm to stabilizer bar.
Tighten link arm to stabilizer bar nut to 60-80 Nm.
Check that ball joint freedom of movement has been maintained.
13. Install road wheel.
14. Repeat procedure steps 1 to 13 on opposite side of vehicle.
15. Raise front of vehicle, remove stands and lower vehicle.
16. Carry out steering geometry and wheel alignment checks and if necessary adjust.
