Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-919003.png)
-
Position subframe on top of tool.
7. Apply 'Alphabond Rapid 101' epoxy adhesive to the shaded area of the bush shown, and the corresponding area of the bush-housing bore.
8. CAUTION: A four-void type of bush is fitted to all vehicles with Comfort specification suspension. A three-void type of bush is fitted to
XJR and vehicles with Sport specification suspension. To ensure satisfactory performance it is essential that the correct type of bush is
installed and both types of bush are correctly positioned in the subframe.
Aligning four-void bush with subframe (Comfort suspension).
-
Align centers of small voids with masking tape markers.
9. Aligning three-void bush with subframe (XJR and Sport suspension).
-
Position bush with large single void facing forward.
-
Align small void centers with masking tape markers.
10. Install bush in housing.
-
Position a steel plate over the bush, ensuring the plate is large enough to cover the rubber flange.
-
Operate the press to install the bush.
