Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-936013.png)
10. CAUTION:
Do not use excessive force when levering hub.
Measure hub end-float.
^
Secure hub carrier in vice.
^
Install special tool JD15 to hub.
1. Install dial gauge JD 13A on hub carrier.
2. Using two levers, measure and record hub end-float.
^
Remove special tools from hub carrier.
11. Using hydraulic press, remove hub and outer bearing assembly from carrier.
1. Position large section of special tool JD132 on press bed, with recess in tool upper most.
2. Position hub carrier on tool, ensuring parking brake cable housing locates in tool recess.
3. Position small section of special tool JD132 on hub.
^
Align assembly to press-ram, and operate press to remove hub from hub carrier.
12. Remove ABS rotor and inner bearing from hub carrier.
^
Remove ABS rotor.
^
Remove inner bearing.
