Vanden Plas (X308) V8-4.0L (AJ27) (2000)
8. Using special pliers, remove and discard inboard circlip from the vertical link.
9. Using special pliers, remove and discard outboard circlip from the vertical link.
10. NOTE: Ensure the vertical link is level, and the supports are situated as near to the bearing bore as possible.
Using a hydraulic press, remove wheel bearing from vertical link.
Position the vertical link so that inboard side of the bearing bore is resting on suitable supports on the press-bed.
Position special tool 204-197 on top of bearing.
Operate press to remove bearing from vertical link, discard bearing.
11. Clean relevant parts.
Installation