Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-609001.png)
Fluid Pump: Service and Repair
Front Seal - Oil Pump
Removal
1. Remove the transmission unit.
2. Remove the torque converter from the transmission unit.
3. Remove the front pump seal.
Remove and discard the seal retaining snap-ring.
Using a 'Snap-on' oil seal puller, remove and discard the seal.
4. Clean the seal housing.
Installation
1. Installation is the reverse of the removal procedure.
2. Use tool 307-357 to install the seal.
Lubricate the seal prior to fitting.
