Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
47. Remove upper wishbone fulcrum shaft securing nut.
^
Repeat procedure to remove securing nut from opposite side fulcrum shaft .
48. Remove wire temporarily supporting hub assembly.
49. Remove wishbone/hub assembly from crossbeam.
^
Supporting hub assembly, withdraw lower wishbone eccentric bolts.
^
Supporting hub assembly, withdraw fulcrum shaft from upper wishbone.
^
Remove wishbone/hub assembly from crossbeam.
^
Repeat procedure to remove wishbone/hub assembly on opposite side.
50. Remove crossbeam front mountings.
^
Remove front mounting heatshield.
^
Remove four bolts securing mounting to crossbeam.
^
Repeat procedure to remove mounting on opposite side.
Installation
Crossbeam 76.10.05
Special Service tools
Tie-Rod-End Taper Separator 211-098 (JD 100)
Engine Support Beam 303-021 (MS 53D)
Installation