Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
3. Remove brake pads from caliper.
1. Remove "R" clips.
2. Withdraw pins from caliper.
3. Remove anti-rattle spring.
4. Remove brake pads.
4. CAUTION: Only remove the bolts securing the caliper anchor bracket to the vertical link. Refer to caution above for more information.
CAUTION: Do not allow the caliper to hang on the hydraulic hose, as this will damage the hose.
Remove caliper from vertical link.
^
Remove bolts.
^
Remove and tie caliper aside.
5. Make sure that wheel bearing end-float is within specification.
6. Measure brake disc run-out.
1. Install brake disc to hub and secure with all wheel nuts, tighten wheel nuts to 20 Nm in a diagonal sequence.
2. Position the gauge so that the pointer contacts the disc, between the disc's outer drill holes and the disc's outer edge.
^
Slowly rotate the disc one revolution, the disc run-out must not exceed the specification.