Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
Air Register: Service and Repair
Fascia Centre Vent Assembly
FASCIA CENTRE VENT ASSEMBLY
Removal
1. Remove battery cover and disconnect ground cable from battery terminal.
2. Remove passenger airbag deployment door for access. Refer to Occupant Restraints.
3. Remove major gauge module veneer panel for access.See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service
and Repair/Procedures
4. Carefully withdraw fascia centre veneer panel.
5. Slacken and remove four screws securing centre vent assembly to fascia.
6. Withdraw centre vent assembly for access, disconnect clock harness multiplug, release clock retaining tangs and remove clock from vent
assembly.
7. Remove and discard the four veneer panel to fascia securing clips.
Installation
1. Fit and fully seat new veneer panel retaining clips to fascia.
2. Fit clock to centre vent assembly, ensuring retaining tangs are fully seated.
3. Position centre vent assembly at fascia and connect clock harness multiplug.
4. Fully seat vent assembly in fascia and fit and tighten securing screws.
5. Fit and fully seat centre veneer panel.
6. Fit major gauge module veneer panel. See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and
Repair/Procedures
7. Fit passenger airbag deployment door. Refer to Occupant Restraints.
8. Connect ground cable to battery terminal and fit battery cover.