Vanden Plas (X308) V8-4.0L SC (AJ27) (2001)
5. Install pivot bearings in hub carrier.
1. Slide bearing over pivot sleeve and seat in bearing cup.
2. Install a 3.905 mm (minimum size) shim to sleeve.
^
Repeat procedure to install opposite end bearing and shim.
6. Press pivot pin sleeve into hub carrier.
^
Install pivot pin in sleeve and position a piece of tube over part of thread.
^
Install pivot pin nut and tighten until shims fully seat on pivot sleeve.
^
Remove nut and tube.
7. Measure bearing pre-load.
1. Position a flat washer to abut shim.
2. Install pivot pin nut.
3. Using a feeler gauge measure and record gap between shim and washer.