X-Type (X400) V6-3.0L (2002)
Brake Switch (Cruise Control): Service and Repair
Speed Control Deactivator Switch 19.75.20
Removal
1. Disconnect the speed control deactivator switch electrical connector.
2. Remove the speed control deactivator switch.
-
Turn the speed control deactivator switch 45 degrees counter clockwise.
Installation
1. NOTE:
-
Operate the brake pedal to allow the speed control deactivator switch plunger to remain in the fully extended position during installation.
-
Releasing and then pulling back on the brake pedal until the pedal reaches the stop in the brake booster, will adjust the speed control
de-activator switch plunger to the required setting.
Install the speed control deactivator switch.
-
Turn the speed control deactivator switch 45 degrees clockwise.