X-Type (X400) V6-3.0L (2002)
Install the rear muffler and tail pipe.
-
Tighten to 55 Nm.
2. Tighten to 25 Nm.
Vehicles with 2.0L engine
3. CAUTION:
-
The exhaust hanger isolators are constructed of a special material. Use only the correct specification exhaust hanger isolators.
-
Check the exhaust hanger isolators for damage or fatigue. Install new exhaust hanger isolators if required.
Install the rear muffler and tail pipe assembly.
-
Attach the rear muffler support isolator.
4. NOTE: Refit the muffler assembly in the same position that was noted in the removal procedure. If refitting a new rear muffler make sure that
there is no torsional stress in the exhaust system, and that the exhaust system is free of the underbody of the vehicle.
Tighten to 55 Nm.