XF (X250) V8-4.2L (2009)
6. LH and RH: Using suitable 800-grit abrasive cloth, remove the molding split line from both rear edges of the door handle strap. (Figure 3)
7. Clean handle.
CAUTION:
Do not use excessive lubricant.
8. Using a KSP 105 from the kit (JLM21206), lubricate the handle strap face, rear, and side surfaces. (Figures 3, 4)
CAUTION:
Do not completely remove the retaining screw.
9. Loosen the retaining screw and slide the handle securing plate rearwards: (Figure 5)
^ Ensure the locating lugs are tight against the door panel aperture.
^ Tighten the retaining screw.