XF (X250) V8-4.2L (2009)
5. Release the cable tie on the squab blower duct. (Figure 4)
6. Maneuver the squab blower motor from the seat frame. (Figure 5)
7. Apply a piece of 25mm X 75mm (1.0in X 3.0in) 3mm thick foam tape from the Squeak and Rattle Repair Kit JLM21205 to the inside face of the
squab blower motor. (Figure 6)
8. Maneuver the squab blower motor into the seat frame.
9. Install a cable tie to the squab blower motor. (Figure 4)
10. Install the three squab blower motor retainers. (Figure 3)
11. Connect the electrical connector. (Figure 2)
12. Install the front seat squab cover rear panel. (Figure 1).
13. Refer to Workshop Manual (GTR) section 501-10, Seating, to install the affected front seat.