XF (X250) V8-4.2L (2009)
A Jaguar-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.
CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.
1. Connect the Jaguar-approved Midtronics Vehicle Power Supply to the vehicle battery.
*
NOTE:
IDS must be loaded with IDS-DVD121_V6.06 or later and Calibration File 35 or later.*
2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. Select Diagnosis from the Session Type selection screen.
5. Select the Selected Symptoms tab, and then select:
^
Electrical > Instruments > Warning Lamps > Engine Malfunction Lamp > Lamp illuminated
6. Select 'continue'.
7. Select the 'Recommendations' tab.
8. From the Recommendations tab, select Run to configure the 'Powertrain control module'
^
Follow all on-screen instructions to complete this task.
9. Exit the current session.
10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.