XF (X250) V8-5.0L SC (2010)
2. Verify the heat shields are attached to the air deflector:
(Figure 1)
^
If a heat shield(s) is missing, continue to step 3 with a new air deflector (C2Z 4201).
^
If a heat shield(s) is partially attached, continue to step 3 with the original air deflector.
3. Using a 5mm drill bit, drill through the five welding points on the left-hand (LH) heat shield and air deflector. (Figure 2)
NOTE:
Ensure five rivets are installed in each heat shield / air deflector.
4. Using a suitable rivet gun, install five rivets (C2C 9428) through the heat shield into the air deflector. (Figure 3)
5. Repeat steps 3 and 4 to the right-hand (RH) heat shield.
6. Refer to Workshop Manual, section 501-02: Front End Body Panels > Removal and Installation > Air Deflector, and front the front air deflector.
Disclaimer