XF (X250) V8-5.0L SC (2010)
2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. From the Session Type selection screen, choose 'Diagnosis'.
5. Select the Selected Symptoms tab, and then select:
^
Body > Glass panels > Glass movement
6. Select 'Continue'.
7. Select the Recommendations tab.
8. From the Recommendations screen, select Run to configure the 'Drivers door module'.
^
Follow all on-screen instructions to complete this task.
9. From the Recommendations screen, select 'Run' to configure the 'Passenger's door module'.
^
Follow all on-screen instructions to complete this task.
10. Exit the current session.
11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > X250-XF > Service Information > 2010 > Workshop Manual
12. Refer to Workshop Manual (GTR) section 501-11, Glass, Frames and Mechanisms, and perform the door window motor initialization procedure.
13. Verify one touch up and anti-trap functions of all windows.
Disclaimer