XJ-12 (X300) V12-6.0L (1995)
Intake Air Temperature Sensor: Service and Repair
Fig. 1
Remove
-
Open the hood and fit a wing cover.
-
Open the trunk and remove the battery cover.
-
Disconnect the battery ground lead.
-
Disconnect the harness plug from the air intake temperature sensor.
-
Undo and remove the air intake temperature sensor and copper sealing washer from the "A" bank intake elbow.
Refit
-
Fitting a new air intake temperature sensor is the reverse of the removal procedure. Fit a new copper sealing washer.