XJ-12 (X300) V12-6.0L (1995)
Engine Speed Sensor: Service and Repair
ENGINE SPEED SENSOR
Fig. 2
Fig. 3
Remove
-
Open the hood and fit a wing cover.
-
Open the trunk and remove the battery cover. Disconnect the battery earth lead.
-
Disconnect the engine speed sensor multi-plug (1 Fig. 2).
-
Undo and remove the sensor mounting bracket securing bolts (2 Fig. 3).
-
Displace the sensor mounting bracket from its locating roll pin (3 Fig. 2).
-
Remove the sensor and mounting bracket assembly from the cylinder block.
-
Push the split grommet out of the mounting bracket and remove it from the sensor lead (4 Fig. 2).
-
Push the sensor lead and multi-plug through the mounting bracket aperture.
-
Undo and remove the sensor to mounting bracket securing bolts and separate the sensor and bracket.
Refit
-
Fitting a new engine speed sensor is the reverse of the removal procedure.