XJ-6 L6-4.2L (1983)
Pick-Up Coil: Service and Repair
Distributor
1.
Remove distributor cap, rotor, and flash shield.
2.
Disconnect wiring from pick-up module to amplifier.
3.
Remove screws securing pick-up module to mounting plate and remove module.
4.
Reverse steps to refit. Be sure to adjust pick-up module air gap to:
0.008 in (0.20 mm) to 0.014 in (0.35 mm)
5.
Adjust ignition timing. Should be:
14° BTDC ..................................................................................................................................................... at idle with vacuum hose disconnected.