XJ-6L (X300) L6-4.0L (AJ16) (1997)
/l6-4.0l_(aj16)/Page-1410004.png)
^
Where the flanging is continued around a corner the corner edge must be split to accommodate the flanging.
^
The replacement panel must be frequently fitted in position to check the fit of the flanged areas and the matching of the corners and edges.
^
When all adjustments have been completed, apply a coat of zinc primer paint to all the bare surfaces on both the body and replacement panels.
^
If the panel is to be tacked in position with puddle welds then an appropriate series of holes should be drilled, every 35 mm, (1.4 in.), in the panel
overlap area, above the wheel well.
^
Apply a generous bead of a suitable adhesive sealant all around the wheel well.
^
Place the panel in position with the flanged portion under the door opening assembly, as shown in Illustration 7, and the overlap area correctly
located.
^
Manually compress the wheel well eyebrow against the inner panel to spread the sealant and ensure that there is full sealant contact around the area.
^
Ensure that the panel is correctly clamped in position at all points and then clean off all surplus sealant.
^
Tack the panel into position.
^
Check the panel position is correct and then complete the spot welds and any further welding to finally secure the panel.
^
Using a suitable abrasive disc clean off all the surplus weld material to provide a smooth surface for the filler.
^
Fill the area and then clean off the surplus filler to provide a suitable base for the painting operation.
PARTS INFORMATION:
WARRANTY INFORMATION:
