XJ-6L (X300) L6-4.0L (AJ16) (1997)
Power Door Lock Actuator: Service and Repair
Fig. 1
-
Remove door veneer panel.
-
Remove door upper trim pad.
-
Remove door lower trim pad.
-
Using a suitable plastic knife, cut through the weather- shield to door sealant and reposition weathershield for access.
-
Disconnect door handle link rod.
-
Disconnect door lock knob link rod.
-
Disconnect motor multi-plug.
-
Undo and remove door glass lower fixings.
-
Undo and remove motor securing bolts.
-
Displace and reposition the glass frame and the motor assembly.
-
Remove the motor assembly (Fig.1).
Fig. 2
-
Remove motor cover.
-
Remove the motor multi-plug inner housing.
-
Using special tool MS 1540 (JD 171), displace door ajar switch harness terminals from multi-plug and note position.
-
Displace and reposition door lock micro-switch.
-
Undo and remove lock motor securing screws.
-
Remove motor/micro-switch assembly and place lock aside (Fig.2).
Refit in the reverse order of the removal procedure.
NOTE: Fig.1 & 2 show front door components only.