XJ-6L (X300) L6-4.0L (AJ16) (1997)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Remove the hydraulic control module. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly
- Antilock Brakes/Service and Repair
2. Disconnect the pump electric motor to ABS/TC CM multiplug (1).
3. Undo and remove two securing screws and remove the ABS/TC CM.
INSTALLATION
1. Clean the mating faces of the hydraulic control module and the new ABS/TC CM. Fit and tighten two securing screws.
2. Re-connect the pump electric motor to ABS/TC CM multiplug.
3. Refit the hydraulic control module.