XJ-8 Sedan (X308) V8-4.0L (AJ26) (1998)
Sliding Roof Panel Control Module: Service and Repair
Synchronising Control Module With Sliding Roof Panel
SYNCHRONISING CONTROL MODULE WITH SLIDING ROOF PANEL
Removal
1. Remove sliding roof trim panel for access. See: Body and Frame/Roof and Associated Components/Sliding Roof/Sliding Roof Panel/Service and
Repair
2. Remove battery cover and disconnect ground cable from battery terminal.
3. Remove roof console for access.
4. Remove sliding roof panel control module. See: Sliding Roof Panel Control Module
Installation
1. Using a drive key or screwdriver in the motor gearbox slot, manually move the sliding roof towards the closed position.
2. Position the sliding roof with an 8 mm gap between the driven lever and the guide rail step.