XJ-8 Sedan (X308) V8-4.0L (AJ26) (1998)
/v8-4.0l_(aj26)/Page-19001.png)
ABS / Traction Control Module: Service and Repair
Special Service tools
Removal
CAUTION:
^
Replacement of nuts and bolts: Various thread-locking devices are used on nuts and bolts throughout the vehicle. These devices restrict the
number of times a nut or bolt can be used.
^
Remove brake fluid spillage immediately from paint work, with clean water.
1. Disconnect battery ground cable.
2. Position vehicle on a four-post lift.
3. Open engine compartment and fit paint work protection covers to fenders.
4. NOTE: The following three pictorial procedures must be carried-out to minimize brake fluid loss when disconnecting the brake tubes.
Open Left-Hand-Front and Left-Hand-Rear caliper bleed nipples.
Connect a bleed tube and container to the calipers.
Open bleed nipples.
5. Depress and hold down brake pedal using special tool.
Position tool between brake pedal and seat frame.
Turn the tool wheel until the brake pedal is held 60 mm down from its released position.
