XJ-8 Sedan (X308) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-255006.png)
Using a hydraulic press, remove wheel bearing from the vertical link.
Position the vertical link so that the inboard side of the bearing bore is resting on suitable supports on the press-bed.
Position special tool 204-197 on top of bearing.
Operate press to remove bearing from vertical link, discard bearing.
14. Clean relevant parts.
Installation
1. NOTE: The gap between the ears of the circlip must be positioned so that it is in the lowest position of the bore when the vertical link is installed
on the vehicle.
Install outboard circlip in vertical link.
2. Using a hydraulic press, install wheel bearing in vertical link.
Position vertical link on the press bed with outboard side of the vertical link face down.
Position wheel bearing on vertical link.
Position special tool on top of wheel bearing.
Operate press to install bearing, applying a three-ton seating load to ensure the bearing is fully seated.
