XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
24. Install crossbeam to engine Hydramount securing bolts.
^
Install bolt securing Hydramount to crossmember and tighten to 22-28 Nm.
^
Repeat procedure to install crossmember opposite side securing bolt.
25. Position and connect harness to steering transducer.
^
RHD vehicles. Position steering harness behind return pipe.
^
Connect harness to transducer.
26. Install power steering pipes on pinion housing.
^
Remove blanks and install new 'O'-ring seals in pipe connectors.
^
Apply power steering fluid to 'O' ring seals.
^
Remove blanking plugs from pinion housing ports.
^
Position pipes on pinion ports and seat 'O' rings.
27. Secure pipes to pinion housing.
^
Ensure pipes and retaining plate are correctly seated.
^
Install bolt and tighten to 9-12 Nm.
28. Secure return pipe on steering rack.
1. Position pipe rubber support on steering rack.
2. Position pipe on support .
3. RHD vehicles. Position harness on pipe support rubber.
4. Secure pipe and harness to support with new tiestrap.