XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
4. Open cupholder, depress tang each side of latch location and withdraw cupholder assembly from base.
5. Slacken and remove the cupholder trim panel securing screws.
Installation
1. Fit trim panel assembly to cupholder mechanism.
2. Fit and tighten the trim panel securing screws.
3. Fit and fully seat cupholder mechanism, ensuring tangs are fully engaged.
4. Fit and tighten lid inner securing screws.
5. Fit cupholder latch and tighten securing screw.
6. Fit Console glovebox lid.
'J' Gate Finisher
'J' GATE FINISHER
Removal
1. Apply protective tape to veneer along each side of 'J' gate finisher.
2. Using a screwdriver in the slot in front of the finisher, carefully lift the finisher and ease it from the 'J' gate surround.
Installation
1. Position finisher over gear selector.
2. Firmly seat finisher on veneer panel.
3. Remove protective tape from veneer panel and using a suitable cleaner, remove any residual adhesive.
'J' Gate Finisher Retaining Panel
'J' GATE FINISHER RETAINING PANEL