XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
2. Remove trunk floor and battery cover. Refer to operations.
3. Remove and discard the two fir tree fasteners securing finisher to trunk rear panel.
4. Pull rear finisher upwards to release upper spring clips and remove finisher from trunk.
Installation
1. Position finisher on trunk rear panel and press firmly downwards to engage spring clips.
2. Fit and fully seat fir tree fasteners.
3. Fit trunk floor and battery cover. Refer to operations.
4. Fit tail lamp covers.
Luggage Compartment Side Trim Panel
Luggage Compartment Side Trim Panel (76.19.22)
Removal
1. Remove trunk floor carpet.
2. Remove trunk front liner.
3. Remove trunk rear finisher.
4. Remove literature pack from trunk side liner (RH side only).
5. Remove side liner from trunk.
Installation
1. Position and fully seat side liner in trunk.
2. Install literature pack on side liner (RH side only).
3. Fit trunk rear finisher.
4. Fit trunk front liner.
5. Fit trunk floor carpet.
Driver Side Cantrail and Upper 'A' Post Trim Pad
DRIVER SIDE CANTRAIL AND UPPER 'A' POST TRIM PAD
Removal
1. Remove rear grab handle. See: Passenger Assist Handle/Service and Repair