XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
1. CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work,
with clean water.
CAUTION: Note condition of pins end "R" clips and replace if necessary.
Install brake pads into caliper.
^
Slowly retract caliper pistons into caliper.
1. Install pads.
2. Position anti-rattle spring.
3. Install pins.
4. Install "R" clips.
2. Repeat above procedure to install opposite side brake pads.
3. Fit wheels.
4. Remove stands and lower vehicle.
5. CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.
Check brake fluid level.
^
Check brake fluid level is at the maximum mark.
^
Remove cloth.
^
Fit cap.
6. Remove paint work protection covers, and close engine compartment.
7. Start the engine and repeatedly press the brake pedal until brake pressure is evident.