XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
/v8-4.0l_sc_(aj27)/Page-251002.png)
-
Whilst holding the tensioner against spring tension, remove drive belt from tensioner pulley. Release tensioner slowly and remove bar.
-
Disconnect belt from other pulleys and remove it from rear of tensioner.
Installation
1. NOTE: Ensure that belt is correctly and squarely located on each pulley. Check belt wear indicator marks to confirm that drive belt is within
limits.
Installation is a reversal of the removal procedure.
