XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
13.
Remove 3.2 mm (1/8 in.) twist drill.
14.
Remove flat metal stock.
Note:
If the gap between A/C compressor bracket and flat metal stock is within specification continue from step 41. If gap is less than 3.2 mm (1/8
in.) continue from step 15.
15.
Recover A/C refrigerant (see Workshop Manual, JTIS CD ROM, section: 412-00, General Procedures, Recover/Reclaim).
16.
Place special tool 303-D055 on the PAS pump pulley and tighten tool belt.
17.
Remove the PAS pump pulley securing screws.
18.
Remove special tool 303-D055 from the PAS pump pulley.
19.
Remove the PAS pump pulley.
20.
Remove the A/C compressor (see Workshop Manual, JTIS CD ROM, section: 412-03, SRO 82.10.20).
21.
Remove the screw securing the engine dipstick tube retaining bracket to the PAS pump (Illustration 3).
22.
Remove the rear bolt securing the A/C compressor/PAS pump mounting bracket to the engine.
23.
Reposition crank sensor harness support clip.
24.
Remove the front bolt securing the A/C compressor/PAS pump mounting bracket to the engine.
25.
Remove the A/C compressor/PAS pump mounting bracket.
26.
Place new A/C compressor/PAS pump mounting bracket to front.