XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
Transmission Position Switch/Sensor: Service and Repair
Selector Indicator Module
Selector Indicator Module
Removal
1. Disconnect battery ground cable.
Remove the battery cover.
2. Remove the selector lever knob.
3. Remove the J-gate surround.
4. Remove the console finisher veneer panel.
5. Remove the selector indicator module screws.
6. Remove the selector indicator module.
Free the D to 4 switch harness multiplug from the mounting bracket and disconnect the multiplug.
Displace the P switch multiplug from the mounting bracket.
Route the D to 4 harness from under the P switch harness.