XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
Tighten nut of special tool 204-114 to full extent, to achieve suspension mid-laden position.
20. Raise front of vehicle and support on stands.
21. Remove front road wheels.
22. Remove crossbeam to engine Hydramount securing bolts.
^
Remove bolt securing crossbeam to Hydramount.
^
Fully withdraw bolt into crossbeam insert.
^
Repeat procedure to remove and withdraw bolt on opposite side
23. Remove lower nut and bolt from front shock absorber.
^
Repeat procedure to remove bolt from opposite side shock absorber.
24. Slacken but do not remove crossbeam rear nuts.
^
Slacken crossbeam LH rear mounting nut.
^
Repeat procedure to slacken crossbeam RH rear mounting nut.
25
Release lower steering column from pinion shaft.
1. Remove lower steering column nut and bolt.
^
Move column upwards to release it from pinion shaft.
26. Disconnect steering rack transducer harness front connector.
^
Release harness connector from body retaining clip.
^
Disconnect connector.
27. Support weight of crossbeam.
^
Position a jack under crossbeam.
^
Place a piece of wood between jack and crossbeam.
^
Raise jack to just support crossbeam.