XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
/v8-4.0l_sc_(aj27)/Page-779007.png)
4. Install guide pins ( supplied with Special Tool 204-111) in spring pan/wishbone bolt locations.
5. WARNING:
WHEN ROTATING TOOL ADJUSTER, ENSURE THAT TOOL STEM DOES NOT TURN AND DISTURB POSITION OF DOWEL IN
SUSPENSION TURRET.
Install spring pan to wishbone securing bolts.
^
Align spring pan with lower wishbone bolt locations.
^
Rotate tool adjuster to gradually increase spring tension.
^
Progressively install but do not tighten spring pan securing bolts.
^
Tighten spring pan securing bolts to 70-90 Nm.
^
Ensure spring lower rubber seat is correctly positioned in spring pan.
6. WARNING:
WHEN ROTATING TOOL ADJUSTER, ENSURE THAT TOOL STEM DOES NOT TURN AND DISTURB POSITION OF DOWEL IN
SUSPENSION TURRET.
Remove Special Tool 204-111 from suspension.
^
Rotate adjuster of Special Tool to release tension on spring.
^
Rotate tool stem to release dowel from turret.
^
Withdraw tool and adaptor .assembly.
7. Lower vehicle to working height and support on stands.
8. Install road wheel.
9. Raise vehicle, remove stands and lower vehicle onto road wheels.
10. Carry out steering geometry and wheel alignment checks and if necessary adjust.
11. Carry out steering geometry and wheel alignment checks and if necessary adjust.
