XJ (X308) V8-4.0L SC (2003)
Wiper Switch: Description and Operation
Wiper and Washer Switch
The wiper and washer switch is on the right-hand side of the steering column and controls the following functions when the ignition switch in position
11.
In the OFF position:
^
The windscreen wiper is stationary and in the parked position. In the intermittent wipe position:
^
The wiper operates intermittently, with a variable time delay between wipes.
^
The time delay can be varied by rotating the column switch collar, which has six positions and varies the delay between two and 20 seconds. The
collar is turned counter-clockwise to increase the delay. In the normal speed position:
^
The wiper operates continuously at normal speed.
In the high speed position:
^
The wiper operates continuously at high speed. Flick wipe operation:
^
Is obtained by pulling the switch stalk towards the steering wheel.
^
Features a single wipe at normal speed if the switch stalk is released immediately.
^
Features continuous wipe action at normal speed while the switch stalk position is held.
Wash/Wipe Operation
The wash/wipe function:
^
Is operated by the button at the end of the switch stalk.
^
Operates the washers and wiper, while the button is depressed, for up to 20 seconds.
^
Provides an additional three sweeps of the wiper after the button is released.
^
Provides a single drip-wipe sweep, four seconds after the wash/wipe sequence has been completed.
^
Is disabled if the 'Washer Fluid Low' message is displayed, but manual operation is still available.
The wash/wipe button also operates the headlamp power wash function (where fitted).