XJ (X350) V8-4.2L (2005)
^
Insert the new foam pad into the remote control key fob where the buttons are situated. (Figure 5)
CAUTION:
Failure to locate the foam pad correctly can result in loss of functionality of the remote control key fob.
^
Carefully assemble the remote control key fob ensuring that the foam pad remains located at all times.
NOTE:
This service action applies to the two fobs originally supplied. Customer purchased key fobs should be handled through normal parts warranty.
2.
If required, carry out step 1 to the second remote control key fob and any owner-purchased key fobs.
3.
Check operation of the remote control key fobs.
NOTE:
If only the foam pad is installed in remotes then no programming is required. If any remote is replaced then all other remotes must be
programmed.
4.
If a new alarm remote is required, refer to GTR Workshop Manual, section: Remote Transmitter Programming, 501-14 and re-program the new
remote control key fob(s).