XJ (X350) V8-4.2L (2005)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Cover - II
Front Bumper Cover
Panel Drawing
MET Tools
Wheel nut wrench
10 mm socket
3/8" Drive ratchet
Torx screw driver
T30 Torx bit
Suitable trim tool
Pozi screwdriver
Panel Tools
None.
01. The front bumper cover is a category B bolt on panel. Remove MET items as listed. Complete 'Pre-Repair Activities'.
The bumper cover is held on with bolts and Torx screws. Remove 8 x T30 Torx screws and 4 x 10 mm bolts.
Push down in the centre of the bumper as indicated to release the clips.
Note: Bolts are pre-coated to inhibit galvanic corrosion and are reusable-only if the coating is undamaged.
02. Remove and fit new panel.
Note:
-
Clamp washer jet hose (if applicable).
-
Disconnect electrical connector.
Specification for C2C 6220 XXX (USA specification illustrated).
Install MET items in reverse order.