XJ (X350) V8-4.2L (2005)
Front Bumper Reinforcement: Service and Repair
Bumper Beam Front - II
Bumper Beam Front
Panel Drawing
Consumables
None.
Mechanical, Electrical and Trim, remove and install:
Front suspension air compressor
(3 x 13 mm nuts)-move to one side
Radiator grille opening cross brace
(2 x 17 mm bolts)
MET Tools
13 mm socket
17 mm socket
3/8" Drive ratchet
Panel Tools
10 mm socket
Torque wrench
3/8" Drive ratchet
Air drill
6.0 mm Wurth drill
6.5 mm Dorma jobber drill
01. The front bumper beam is a category B bolt on panel. Remove MET items as listed. Complete 'Pre-Repair Activities'.
02. The beam is attached to the crush tubes with 4 x SPR fixings and bolts.
Drill fixings (x 4) as shown. These fixings are not replaced when new assembly is fitted as they are for manufacturer's assembly and do not require
reinstating by repairer.